Haywire twist
Ties single-strand wire to a hook, lure or swivel, for toothy fish.
- Use
- Line to hook or lure
- Lines
- Wire
- Difficulty
- Hard
White: the line to your reel. Orange: the tag end, the part you move. Mirror flips the drawing for tying left-handed.
Steps
Pass the wire through the eye and fold the end back, about 15 cm, to make the loop.
Cross the two strands at a wide angle and twist them round each other, so both wind round each other, not one round the other.
Keep going for 5 to 8 twists.
Bend the tag end to a right angle and wrap it tightly round the standing wire alone: 4 to 6 close barrel wraps.
Bend the tag end into a crank handle and turn it until it breaks off at the last wrap. Never cut it.
Tips
- Break the tag end off with the crank. A cut end leaves a sharp burr.
- It is for single-strand wire.
Sources
Each step was checked against these written guides:
- Salt Water Sportsman, How to finish a haywire twist
- Leadertec, Basic haywire twist and barrel wraps
- Salt Water Sportsman, Wire leader tips for fishing
Drawings and animation by Fishwake. We give no breaking-strength figures: published numbers differ with the line and the test.
